Quatech Audio/Video Capture USB 2.0 Dokumentacja Pobierz pdf (Strona 68)

100

101

4-8 z.one ultra and z.one ultra sp OPERATOR MANUAL

Figure 4-6. Scan Engine Battery Charger

 To Charge a Battery

Refer to Figure 4-6 as you read the following instructions.

1. Connect the AC power cable of the Battery Charger’s power supply to an

active wall outlet.

2. Connect the DC power cable of the Battery Charger’s power supply to the

Battery Charger.

3. Insert the battery into the either bay of the Battery Charger.

4. Charging of the battery will begin. While charging, the status LED for that bay

will flash GREEN.

5. When the battery is fully charged, the status LED becomes solid GREEN (no

flashing). (See also

Table 4-3.)

NOTE: You can place two batteries for recharging in the Battery Charger at the

same time. The charger will recharge them sequentially, fully charging one battery

before charging the other battery.

 To Recalibrate a Battery

1. Connect the Battery Charger’s AC and DC power cables as described for

charging a battery (above).

2. Insert the battery into the LEFT bay of the Battery Charger only (see

Figure 4-6). You cannot recalibrate a battery if placed in the other bay.

3. Press the Recalibrate button on the Battery Charger. Recalibration will begin.

4. During recalibration, the left status LED will flash ORANGE.

5. When the battery is fully recalibrated, the left status LED will flash ORANGE

and

GREEN (see also Table 4-3).

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 403 404

Komentarze do niniejszej Instrukcji

Brak uwag

Quatech Audio/Video Capture USB 2.0 Dokumentacja Strona 68

Komentarze do niniejszej Instrukcji